Configuring Vlan Settings - Cisco Access Registrar 4.2 Configuring Network Settings

Modifying VLAN Settings
Modifying VLAN Settings

Configuring VLAN Settings

Using the Phone Configuration Web Page
Step 1
Step 2
Step 3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
4-26
You can change the administrative VLAN used by the Cisco Unified IP Phone
and, on the Cisco Unified IP Phone 7905G and 7912G, you can disable or enable
VLAN manually.
This section covers the following topics:
Configuring VLAN Settings, page 4-26
•
Disabling VLAN, page 4-27
•
If you configure an administrative VLAN manually, that setting overrides the
auxiliary VLAN configured on a Cisco Catalyst switch in which the phone is a
member.
To assign an administrative VLAN for the Cisco Unified IP Phone, follow these
steps:
Procedure
Display the Phone Configuration web page.
For instructions, see the
Configuration Web Page" section on page
In the pane on the left under Change Configuration, click Network Parameters.
You may be prompted to enter a password.
The Network Parameters web page appears.
In the VLANSetting field, enter a VLAN ID into bits 18–29 and click Apply.
For more information about this field, see the VLANSetting parameter in
Table A-5 on page A-16.
Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone
"Accessing Network Settings through a Phone
4-2.
OL-8617-01