Inter-Tel Axxess Administrator's Manual page 32

Administrator Procedures
®
AXXESS ADMINISTRATOR'S GUIDE – January 2004
6.
7.
8.
Page 16
c. Toll Restriction: This option allows you to set the station class of service for day
and/or night modes. To select it, press
ton. Then do the following:
1. The display shows TOLL RESTRICTION OPTION. Press
DAY menu button to program day mode toll restriction. Or, press
COS NIGHT menu button to program night mode toll restriction.
2. The display shows SET DAY (or NIGHT) COS XX. If this is not the COS
you wish to program, scroll to the correct COS by pressing the high end of the
Volume button or NEXT to scroll forward, or press the low end of the Volume
button or PREVIOUS to scroll backward. The default COS numbers are as
follows. See page
COS 01 – ARS Only
COS 02 – Deny Area/Office
COS 03 – Deny Operator
COS 04 – Deny Toll Access
COS 05 – Deny International
COS 06 – Deny Equal Access
COS 07 – Deny Local Calls
COS 08 – Denied Numbers
COS 09 – Allowed Numbers
3. When the correct COS is displayed, press
enable the toll restriction. Or, press
4. If desired, repeat steps c2 and c3 to program additional COS toll restrictions.
5. Press or ACCEPT to save the COS programming. The display shows
#
DATABASE UPDATED and then returns to the TOLL RESTRICTION
OPTION prompt.
6. Press
again to exit to the ENTER STATION OPTION prompt.
#
When the display shows ENTER STATION OPTION, press
ENTER STATION EXTENSION prompt. You can then program another station by
repeating these steps or press
BASE OPTION prompt.
When finished with all programming, press
OPTION prompt is displayed. This ends the programming session.
If a system reset is required, the display shows ENTER SYS RESET OPTION. Do one
of the following:
— Delayed Reset: Press
display shows DELAYED RESET SCHEDULED. The system will be reset at the
pre-programmed time.
— Immediate Reset: Press
now.
NOTE:
A system reset will drop all calls in progress.
or the TOLL RESTRICTION menu but-
3
155.
or the OFF menu button to disable it.
2
or ACCEPT once more to exit to the ENTER DATA-
#
#
or the DELAYED menu button to delay the reset. The
1
or the IMMEDIATE menu button to reset the system
2
or the COS
1
2
or the ON menu button to
1
again to exit to the
#
while the ENTER DATABASE
Station Programming
or the