Redialing - Inter-Tel Axxess Administrator's Manual

REDIALING

The Redial feature can store one telephone number in redial memory at the station. If the sta-
tion user reaches a busy number, is disconnected, or if there is no answer, the number can be
redialed easily. The station user simply lifts the handset and presses the
enters the Redial feature code. A trunk access code is automatically entered, and the telephone
number is redialed. (If redialing while still connected to an outside call, the connection is
dropped, and the trunk is reseized before the number is dialed.)
Only one telephone number can be stored in the station's redial memory at a time. This number
can be stored in one of two ways, depending on station programming:
•
•
The Last Number Saved and Last Number Dialed features work differently depending on the
station status when it is used, as shown in the table below. Individual station programming
determines the mode of the Redial feature (Last Number Dialed or Last Number Saved). The
Redial feature code (380) performs the redial function (programmed under the
Non-display system speed-dial numbers cannot be redialed at a display phone.
STATION STATUS WHEN
REDIAL FEATURE IS USED
Idle station
Intercom dial tone (on or off
hook)
On an intercom call
After selecting a trunk but
before dialing
After selecting a trunk and
dialing one or more digits
On an incoming outside call
Redialing
AXXESS
Last number saved: The desired number is manually stored in redial memory by the
station user. Dialing other numbers does not change the stored number. It only changes
when a new number is stored.
Last number dialed: The last number manually dialed or speed dialed is automatically
stored. It changes every time the user dials a telephone number. (This is the default
value of the Redial feature.)
STATION HAS
"LAST NUMBER SAVED"
Saves the last trunk access code and
telephone number that was dialed.
Saves the last trunk access code and
telephone number that was dialed.
Releases the current call, seizes a trunk
using the saved trunk access code, and
dials the saved telephone number.
Redials the saved telephone number on
the currently selected trunk. (Note that
the current trunk is used instead of the
saved trunk access.)
Releases the current call, seizes a trunk
using the saved trunk access code, and
dials the saved telephone number.
Releases the current call, seizes a trunk
using the saved trunk access code, and
dials the saved telephone number.
®
ADMINISTRATOR'S GUIDE – January 2004
STATION HAS
"LAST NUMBER DIALED"
A trunk is selected using the same trunk
access code as used to place last out-
side call, and the last telephone number
is dialed.
A trunk is selected using the same trunk
access code as used to place last out-
side call, and the last telephone number
is dialed.
Releases the current call, seizes a trunk
using the access code used on the last
outside call, and dials the last telephone
number dialed.
Redials the last telephone number
dialed, using the currently selected
trunk.
Releases the current call, reseizes the
trunk (using the access code used on
that call), and redials the digits that were
dialed.
Releases the current trunk, seizes a
trunk using the same trunk access code
used on the last outgoing call and dials
the last number dialed.
System Features
button or
REDIAL
button).
REDIAL
Page 243