Setting Network Date And Time - Inter-Tel Axxess Administrator's Manual

SETTING NETWORK DATE AND TIME

Occasionally, the network time or date needs to be reset (for example, when the system is
defaulted or for daylight-saving time). Any administrator can change the date and time that
appears on all display phones and in the SMDR reports in the network. The day of the week is
automatically calculated and set by the system when the date is entered.
T
O SET THE NETWORK DATE AND TIME
NOTE:
unchanged and start over.
1.
2.
3.
4.
Setting Network Date and Time
AXXESS
If you make a mistake, press
While on hook, enter the Set Network Date and Time feature code (9810). Your display
shows DATE (current date).
If you do not need to change the date, press
XX:XX prompt.
Use the dialpad buttons to enter the month, day, and year. For example, press 020301
for February 3, 2001. When finished, the display shows TIME (current time).
NOTE:
If using a station programmed for Japanese, enter the date as year, month,
date. For example, 010203 for February 3, 2001.
If you entered the date incorrectly, the display shows INVALID DATE, and you are
prompted to enter a new date.
If you do not need to change the time, press
shows SYSTEM DATE AND TIME UPDATED.
Use the dialpad buttons to enter the time in hours and minutes. (For example, enter
0900 for 9:00.)
NOTE:
If using a station programmed for Japanese, the prompts will be reversed and
you will set the AM/PM before the hour and minutes.
If you entered the time incorrectly, the display shows INVALID TIME, and you are
prompted to enter a new time.
If the node is set for 12-hour display format, the display shows SELECT AM OR PM
(AM=1 PM=2). Press
1
menu button) for PM. The display shows SYSTEM DATE AND TIME UPDATED. If
you press any button other than 1 or 2, the display shows INVALID TIME, and you are
prompted to enter a new time.
®
ADMINISTRATOR'S GUIDE – January 2004
:
to backspace or press
MUTE
or ACCEPT to skip to the TIME
#
or ACCEPT twice to exit. The display
#
(or the AM menu button) for AM or press
Administrator Procedures
or CANCEL to leave it
(or the PM
2
Page 11