Inter-Station Messages - Inter-Tel Axxess Administrator's Manual

System Features
®
AXXESS ADMINISTRATOR'S GUIDE – January 2004

INTER-STATION MESSAGES

Intercom callers may leave a message waiting indication if a called station is busy, if there is
no answer, if the station is in Do-Not-Disturb, or when they are connected to or placed on hold
by another station. Users are allowed to leave message for, and respond to messages from,
users on other nodes. There are two messaging options:
•
•
To signal that a message is waiting, a called Inter-Tel phone's
display shows the number of waiting messages. Each time the
display shows the message source for each of the waiting messages in the order they were
received. For messages from stations, the display shows MSG: (station) and the date and time
of the message. For messages from voice mailboxes, the display shows XX MESSAGES
FROM MBOX XXXX to indicate the number of waiting messages in each mailbox that left a
message. (This is especially helpful at stations with multiple mailboxes.) For single-line sets, a
system programming option can be enabled that sends six short message waiting tones when
the user lifts the handset or presses the hookswitch.
NOTE:
right-hand corner of the phone. If programmed for the Message feature, this lamp flashes/lights
whenever the
Any station, Voice Processor application, hunt group, or off-node device can be designated as
the message center for a station. However, a station cannot be programmed as its own message
center.
If the designated message center is a voice mail hunt group, the voice mail hunt group is called
after the Message Wait timer expires. When the voice mail unit answers the call, the called
party's "mailbox" is automatically dialed. The caller can then leave a message in the mailbox.
The called party's
was left by the voice mail hunt group.
Each station user can leave message waiting indications at more than one station. If more than
one message is received from one station, the message display will show only the first mes-
sage, and all other requests will be ignored.
When a station is forwarded or has system forwarding, and a caller leaves a message waiting
indication after calling the forwarded station, the message indication appears at the original
station instead of the station that received the forwarded call.
Page 182
Have the called party return your call. Display phones show the source and time of
the message. When the called party responds to the message indication, a call is auto-
matically placed to your station.
Leave a message with the called party's message center. Display phones show that a
message was left with the phone user's assigned message center. When the called party
responds to the message indication, a call is automatically placed to his or her message
center.
Model 8500, 8520, and 8560 Phones have a Message Lamp located on the upper,
button flashes/lights. See
MSG
button flashes, and the message display indicates that the message
MSG
button flashes, and the
MSG
button is pressed, the
MSG
page 116 for details.
Inter-Station Messages