Platen
Removal
1.
Turn off the printer and remove the AC power cord, media, and ribbon if
installed.
2.
Remove the printer cover (see page 7–3).
3.
Remove the lower timing belt (see page 7–11).
4.
Remove the three (3) 6–32 X .38 Phillips screws securing the control
panel assembly.
5.
Raise the printhead and lower the lower right front panel.
6.
Remove the control panel assembly and disconnect the front panel
cable assembly.
7.
Using an Allen wrench inserted in the set screw access slots shown
above, loosen the set screws in both the 36 tooth and 51 tooth pulleys
attached to the platen shaft.
Removal and Replacement
Figure 7–19
7–19