Table of Contents
Advertisement
12. Using the Secondary Operator's Panel, enable the printer reflective gap
sensor.
13. Place the red (+) voltmeter probe on TP10 on the Printer Controller
PCBA.
14. Adjust R2 on the Printer Controller PCBA until the voltmeter reads 0.750
VDC (range 0.700–0.800 VDC).
15. Re-install printer cover (see page 7–4).
4–10
Maintenance and Adjustments
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the T3204 and is the answer not in the manual?