Table of Contents
Advertisement
Never Do the Following
Handling of ink cartridges
•
Ink is organic solvent.
If ink settles on the skin or
clothes, immediately wash it off
with detergent or water.
If you get ink in your eyes,
immediately wash your eyes with
a lot of clean water for at least 15
minutes. In this case, also wash
the backside of eyelids to rinse
ink away completely. Then,
consult a doctor as soon as
possible.
•
Store ink cartridges and waste ink
tank in a place that is out of the
reach of children.
•
Never refill the ink cartridge with
ink.
MIMAKI assumes no
responsibility for malfunction
caused by using the device after
replenishment of ink.
During assembly
•
The pack of the device is as
heavy as approximately 200 kg.
Perform the assembly work by at
least four persons.
Do not disassemble or remodel the device.
•
Never disassemble or remodel
the main unit of the printer and
the ink cartridge. Disassembling/
remodeling any of them will
result in electric shocks or
breakdown of the device.
WARNING
Do not use the device in damp places.
•
Avoid damp environments when
putting the device into service.
Do not splash water onto the
device.
High-humidity or water will give
rise to fire, electric shocks or
breakdown of the device.
Abnormal event occurs.
•
If the device is used under an
abnormal condition where the
device produces smoke or
unpleasant smell, fire or electric
shocks can result. Be sure to
turn off the power switch
immediately and detach the plug
from the receptacle. Check first
to be sure that the device no
longer produces smoke, and
contact a distributor in your
district for repair. Never repair
your device by yourself since it is
very dangerous for you to do so.
Power supply and voltage
•
Be sure to use the device with
the power supply specifications
indicated. Set voltage selectors
according to the power voltage to
be used.
110V : JV3 ••• 100-120V
220V : JV3 ••• 220-240V
•
Be sure to connect the plug of
the power cable to a grounded
receptacle. If not, fire or electric
shocks can result.
Handling of the power cable
•
Use the supplied power cable.
•
Take care not to damage, break
or work on the power cable.
If a heavy matter is placed on the
power cable, heated or drawn,
the power cable can break to
cause fire or electric shocks.
- vi -
Advertisement
Table of Contents
