Table of Contents
Advertisement
STEP
1. Put the device into the LOCAL mode.
2. Push the [FUNCTION] key.
3. Push the [ENTER] key.
4. Push the [ ] and [ ] key to select a type.
page 4.4
5. Push the [ENTER ] key.
6. Push the [ENTER] key.
7. Enter a correction value from the output pat-
tern.
Enter the correction value by pushing the JOG keys [ ] and
[ ].
• When [ADJUST] is changed to 30, the pattern
moves by about 0.1 mm. Determine the correc-
tion value referencing this amount of movement.
8. Push the [ENTER] key.
Register the correction value.
Repeat steps 6 to 8 until normal plotting result is obtained.
9. Push the [END] key three times, and the menu
returns to the LOCAL mode.
- 2.23 -
< LOCAL >
width : 1272 mm
FUNCTION
SET UP
< ENT >
SET UP
SELECT
: TYPE. 1
SET UP
SELECT
: TYPE. 1
TYPE. 1
MEDIA COMP.
< ent >
TYPE. 1
PRINT START
TYPE. 1
ADJUST
=
TYPE. 1
PRINT START
< LOCAL >
width : 1272 mm
: ent
20
: ent
Advertisement
Table of Contents
