Table of Contents
Advertisement
1. Move the carriage to the platen.
When the device is turned on : Execute [CARRIAGE OUT].
When the device is turned off : Open the front cover, then
2. Loosen two screws mounted on the front face
of the head with a coin or the like.
3. Adjust the height adjusting lever according to
the medium to be used.
• Set the height adjusting lever to the highest
stage or the lowest stage.
Setting it to the intermediate height, a plotting
fault can result.
4. Keeping the height adjusting lever held at the
aforementioned position, tighten the two
screws.
• If you tighten the screws without keeping the
height adjusting lever held at the set position,
the head may not be secured at the normal
position.
• Fasten the screw securely.
5. Return the carriage to the station position.
page 5.4
move the carriage.
- 2.7 -
Advertisement
Table of Contents
