Table of Contents
Advertisement
8. Remove the ink at the wiper and the bracket
using a cotton bud dampened with cleaning
fluid RS.
•
If dirt of curl is serious, replace the wiper with a
new one. At the time of replacement, be sure to
terminate the plotter operation and follow the
wiper replacement procedure.
9. Holding the projections at both ends, insert the
wiper which has cleaned into place.
10. Wipe off ink or dirt adhered to the rubber of the
cap and the ceiling of the wiper cover using
cotton buds.
•
Be careful not to leave lint of the cotton bud. Lint
may cause plotting failure.
11. Push the [ENTER] key.
The carriage return to the capping station, and the initial
operation is performed.
page 5.5
- 3.5 -
Wiper Cover
INITIALIZING
PLEASE WAIT
< LOCAL >
Advertisement
Table of Contents
