Adjusting The Head Height When The Fabric Used Is Changed [Head Height] - MIMAKI Tx2-1600 Operation Manual

6. Close the left maintenance cover, then press the
[ENTER] key.
• In the case where a fabric is loaded on the
printer, the fabric detection display will appear
on the LCD after the initialization.
The menu enters the LOCAL mode.

Adjusting the head height when the fabric used is changed [HEAD HEIGHT]

For the procedure of adjusting the head height, See page 1-36.
• Before adjusting the head height, be sure to remove the fabric from the platen.
If an attempt is made to adjust the head height with the fabric kept set on the
platen, the fabric gets caught on the carriage during "carriage out" operation,
causing damage to the head.
- 4.24 -
I N T I A L I Z I N G
P L E A S E WA I T
< < L O C A L > >
w i d t h : 1 2 7 2 m m