Table of Contents
Advertisement
Setting a paper roll on the device
The procedure for setting roll medium on the device is described below.
• The roll medium is heavy in weight. Take care not to drop it on your foot.
1. Pull up the clamp lever at the back of the de-
vice.
When the roll holder is attached at the top or bottom position,
it is necessary to use the lock pin.
page 2.14
2. Loosen the screw of the left-hand roll holder.
3. Determine the position of the roll holder.
The inside diameter of the roll medium core may be 2 inches
or 3 inches.
A roll holder is tighten with screws along the sticker [Roll
holder set].
4. Insert the let-hand roll holder into the core of
the roll medium.
Push roll medium onto the roll holder till the roll core no
longer moves.
5. Loosen the screw of the right-hand roll holder.
Adjust the roll holder position to the width of the roll medium.
• By placing the roll medium on the medium
support bar, the position of roll holder can be
adjusted easily.
- 2.10 -
Advertisement
Table of Contents
