When The Image Quality Is Not Good - MIMAKI UCJV330 Print Manual

When the image quality is not good

If you use the clear ink according to the procedures in this Guide, the settings will be made so that good-quality
images are obtained, with the specified quality feel. Sometimes however, the image quality may be poor due to
the media material or other factor. In that case, change the setting of 1-4 of the following procedures, please do a
test print.
1.
Turn on the printer's power.
• UCJV300: Wait until the Local mode.
• UCJV330: Wait until the Media Select mode.
• If the power is already on, UJV300 set to the Local mode and UCJV330 set to the Media Select
mode.
2.
Select the panel to press [MAPS] setting display, as follows:
• For UCJV300
(1) With <Local> displayed, press the
(2) Use the
(3) Use the
(4) Use the
• For UCJV330
(1) With [MENU] on the display, press the corresponding [FUNC] key.
(2) Use the
(3) Use the
(4) Use the
3.
Select "MANUAL", as follows:
(1) Press the
(2) Use the
4.
After setting to "MANUAL", make the settings for the ink colors, as fol-
lows.
(1) Press the
(2) Make the setting for [COLOR], as follows.
Use the
Changing this value will change the color image quality.
Then press
(3) Make the setting for [SPOT], as follows.
Use the
Changing this value will change the spot color image quality.
Then press
(4) Return to <Local>, by pressing the
key to select [SETUP], then press the
key to select [SETUP 1] to [SETUP 4], then press the
key to select [MAPS4], then press the
key to select [Media Setting], then press the
key to select the media to be used, then press the
key to select [MAPS], then press the
key.
key to select "MANUAL".
key.
key to change level. (0 to 100%)
.
key to change level.
.
- 4 -
key.
key several times.
key.
key.
key.
key.
key.
key.