Table of Contents
Advertisement
STEP
1. The device enters the LOCAL mode.
Push the [REMOTE] key and put the device back into the
LOCAL mode.
2. Push the [TEST&CLEANING] key.
3. Push the [ENTER] key.
The device plots the test pattern.
4. Check the test patterns.
If a failure occurs, proceed with step 5; otherwise, terminate
the operation.
5. Push the [TEST&CLEANING] key twice.
6. Select the method of cleaning by pushing the
JOG keys [ ] and [ ].
soft
:
Select this if there is any missing line.
normal
:
Select this if any line is bent.
strong
:
Select this if inferior plotting cannot be
recovered after [normal] or [soft] cleaning.
7. Push the [ENTER] key.
Cleaning starts. The operation status is displayed as * in the
second line.
8. The device revert the LOCAL mode.
9. Repeat steps 2, and check the result of the test
plotting.
Repeat steps 2 to 7 until normal plotting result is obtained.
TEST &
CLEANING
TEST &
CLEANING
- 2.21 -
< LOCAL >
width : 1272 mm
TEST DRAW
< ENT >
∗ ∗ TEST DRAW ∗ ∗
< LOCAL >
width : 1272 mm
CLEANING
TYPE
: normal
CLEANING
TYPE
: normal
CLEANING
TYPE
CLEANING
TYPE
: strong
CLEANING
ACTIVE
∗ ∗ ∗ ∗ ∗ − − − − − − − − − − −
< LOCAL >
width : 1272 mm
: soft
Advertisement
Table of Contents
