Table of Contents
Advertisement
MENU mode
There are the following four mode in this device.
Each of the four modes is explained below.
< NOT-READY > mode
This is the mode before the medium detector.
The keys other than the [REMOTE] key are effective.
< LOCAL > mode
This is the mode after the medium detection.
All keys are effective to enable setups.
The device is able to receive data from computer, however, it will not perform plotting.
In this mode, it is possible to perform the following operations.
1. Pushing the appropriate [JOG] keys to detect a medium and set up an origin.
2. Pushing the [TEST&CLEANING] key to start test plotting and cleaning the head.
3. Pushing the [DATA CLEAR] key to erase the plotting data the device has received.
4. Pushing the [FUNCTION] key to set plotting conditions.
5. Pushing the [HEATER] key to set temperature of the heater.
< REMOTE > mode
The device plots an image from data it receives.
During the plotting operation, push the [REMOTE] key to interrupt the plotting operation.
< FUNCTION > mode
This is the mode in which plotting conditions can be set.
While the device is in the LOCAL mode, push the [FUNCTION] key to put the device into the
FUNCTION mode.
- 1.14 -
Advertisement
Table of Contents
