Table of Contents
Advertisement
Precautions in use
Heater
•
Do not spill liquid on the platen
as this may cause failure of the
heater or ignition.
•
Do not touch the platen heater
with bare hand while it is hot as
this may cause burn.
•
When moving the device, wait
unit the heater temperature
drops.
As a criterion, wait at least 30
minutes since you turn off the
power of the heater.
The device can be moved within
the same floor without steps.
When moving it to a different
place, contact representative of
Mimaki Engineering.
Use the ink specified
•
Use the JV3 genuine ink.
The plotter does not operate
with other ink than the JV3
genuine ink.
•
Do not use the JV3 genuine ink
for other plotters as doing so
may cause damage to other
plotters.
Periodic exchange parts
•
There are some parts which
must be replaced by service
men. You have to make a
contract with distributors or
dealers for after-sale service.
Power supply
•
Leave the breaker turned ON.
•
Do not turn OFF the main power
switch on the rear face.
CAUTION
Protection against dust
•
It is strongly recommended to use
the device in a room that is not
dusty. Set the Refresh level 2 or 3
when in bad environment.
(
•
Keep the front cover to be closed
also when the device is not
engaged in printing. If not, dust can
accumulate on the head nozzle.
•
When leaving the workshop after
the working hours, be sure to take
off any medium from the roll
hanger. If any medium is left on the
roll hanger, dust can put on it.
•
Store medium in a bag. Wiping off
dust accumulated on a medium will
adversely affect the medium due to
static electricity.
•
Frequently wipe the capping station
clean to eliminate dust and paper
chips.
•
Dust in the head will also cause
drops of ink to fall abruptly down on
the medium during printing. If this
phenomenon takes place, be sure
to clean up the head.
(
Front cover and lever
•
Never open the front cover and/or
lever during printing. Opening the
cover or lever will abort printing.
- viii -
page 4.8)
page 2.21, 4.9)
Advertisement
Table of Contents
