Table of Contents
Advertisement
The REAR
2
3
9
8
Name
1
Rear exhauster
2
Ink station
3
Ink cartridge
4
Parallel connector
5
IEEE-1394 connector
6
Paper roll setting bar
7
Roll holder
8
AC inlet
9
Main power switch
10
Clamp lever
11
Preheater
11
10
Discharges plotting smell from the medium to out of the room.
Set the ink cartridges specified.
Each cartridge contains ink of a specific color.
Bi-directional parallel interface connector (complies with IEEE1284)
A 400M bps interface connector compatible with IEEE-1394.
This bar facilitates a paper roll to be set in position.
Roll holder is inserted in the right and left core of roll medium to hold
the roll medium. The roll holder is applicable to diameter of medium
cores with 2 and 3 inches. The attachment position (height) of the roll
holder can be set in three steps. To increase the heater contact time,
attach it at the bottom position.
The power cable is connected to the AC inlet.
Turns on/off the main power of the device. Leave the main power turned
on to prevent ink clogging.
Works together with the clamp lever on the font face of the device.
Preheat the medium before plotting. ( Attached inside the platen )
- 1.5 -
1
Function
2
3
4
5
6
7
Advertisement
Table of Contents
