Table of Contents
Advertisement
About entering media remaining
amount
When you set [Media remaining amount display] to "ON"
(
P.3-14), you are prompted to enter the media
remaining amount after completing the setting of the
Logical Seek.
When the setting of the Logical Seek is
1
completed, you are prompted to "Input
Media Length".
Media Detect
Logical Seek
Input Media Length
• When you set "Media remaining amount display"
of the machine setting to "OFF", this screen is not
displayed. (
P.3-14)
Press
to enter the media
2
remaining amount.
Press the
3
Quality
50.0m
key.
Detecting media width when media
detection method is "MANUAL"
Press
to select a media (roll or
1
leaf).
• The media detection screen appears.
Media Detect
Set number of
Print Area
Press
to enter the number of
2
mounted media, and press the
key.
Select and press the
3
• The "RIGHT EDGE POSITION" screen will be
displayed.
Press
to move the head, align
4
the LED pointer to the right edge of the
media and press the
• The "LEFT EDGE POSITION" screen will be
displayed.
In the same way as in step 4, decide the
5
left edge position of the media and press
the
key.
• Media width is set.
• When the media detection is completed, the
screen of "Setting a roll media as described in
step 21 is displayed.
Follow the steps 22 and later.
Setting a narrow roll media
When you use narrow roll media (up to 1.6m), set the
media on the narrow roll holder.
• At the take-up side, set the printed surface to
"involuted". (If you set it to "revoluted", it may
adversely affect the media feeding.)
• When setting a media, place the media in the
center of the machine . If the media is set to the
right or left, the media may not be transported
normally.
Set the setting of the feeding unit to "OFF"
1
in "Setting Feeding unit" of the machine
setting. (
P.3-13)
Open the front cover and rear cover.
2
1
MANUAL
key.
key.
Front cover
Rear cover
2
2
2
2
2-9
Advertisement
Table of Contents
