Programming Groups Of Default Settings - Oce 9800 User Manual

Programming groups of default settings

Groups of default printer settings can be stored in a program. Besides the
standard default settings, up to five extra groups of default settings can be
stored under a program button. This section explains how to store settings
under a button, what feedback is provided on the display, and how to erase
programs.
When the Océ 9800 is installed, the standard 'Default settings' program
contains the factory default settings. Refer to Appendix A for a complete
overview.
Not all factory default settings are visible in the 'Default settings' area. The
area can contain up to 8 values. The most important settings are:
the number of copies
sort by set/sort by page
the selected roll number and whether auto-roll has been pressed. This will be
indicated as: (auto)
the zoom factor
print delivery (if applicable)
Other settings that can be displayed in the remaining 2 or 3 lines are:
synchro cut/standard cut/custom cut
fold (always visible if switched on)
edit: shift, auto shift
Only 'Shift', 'Mirror' and 'Autoshift' are used. 'Stretch' and 'Erase'
Note:
are not used, and should be ignored.
stamp (always visible if switched on)
bin number of High Capacity Stacker (optional)
Changing the Océ 9800 standard 'Default' settings
Make the settings.
1
Press the section button 'Program'.
2
Select 'Store' using the higher/lower buttons.
3
Press the function button 'Default settings'. The system will ask you to
4
confirm.
The new defaults are now stored in memory. Note that not all active settings
can be displayed. The maximum number to be displayed is eight.
When ready, quit the key operator mode.
5
68 Océ 9800 Printer User Manual