Programming Groups Of Default Settings - Oce 9800 User Manual

Programming groups of default settings

Groups of default printer settings can be stored in a program. Besides the
standard default settings, up to five extra groups of default settings can be
stored under the five program buttons. This section explains how to store
settings under a button, what feedback is provided on the display, and how to
erase programs.
When the Océ 9800 is installed, the standard 'Default settings' program
contains the factory default settings. Refer to Appendix A for a complete
overview.
Not all factory default settings are visible in the 'Default settings' area. The
area can contain up to 8 values. The most important settings are:
the number of copies
sort by set/sort by page
the selected roll number and whether auto-roll has been pressed. This will be
indicated as: (auto)
the zoom factor
print delivery (if applicable)
Other settings that can be displayed in the remaining 2 or 3 lines are:
synchro cut/standard cut/custom cut
fold (always visible if switched on)
edit: shift, auto shift
Only 'Shift', 'Mirror' and 'Autoshift' are used. 'Stretch' and 'Erase'
Note:
are not used, and should be ignored.
stamp (always visible if switched on)
Storing settings under a program button
Define the settings you want to store under a program button.
1
Press the 'Program' section button.
2
Select 'Store' using the higher/lower buttons (see figure 59).
3
68 Océ 9800 Printer User Manual