Refilling Toner - Oce 9800 User Manual

Refilling toner

If the toner indicator flashes in the display, you should add toner. This can be
done at any time, even while a job is printing. You will be able to finish your
current job.
If you do not add toner in time, the system will stop.
Note:
Adding the toner
Shake the toner bottle well, then unscrew the cap.
1
Open the front top cover.
2
Attention:
Open the toner re-fill opening.
3
Do not remove the seal of the bottle opening.
Note:
Position the bottle with the ridge into the notch of the fill opening and push it
4
down (see figure 87).
[87] Pushing the toner bottle into the fill opening
The seal at the bottle opening will automatically be cut at the entrance of the
toner reservoir, allowing the toner to flow out of the wide bottle neck.
Tap the toner out of the bottle.
5
Just add one bottle at a time.
Note:
When the bottle is empty, remove it carefully.
6
Close the fill opening
7
Close the top cover by lifting up the cover and pulling the hinge towards you
8
(see figure 88).
Maintenance
Only use 9700/9800 toner.
95