Table of Contents
Advertisement
NTI VOPEX-USBV-2 KVM SPLITTER
OPERATION
Mode Selection
The VOPEX comes equipped with four (VOPEX-USBV-2) or six (VOPEX-USBV-4) modes of operation. To manually toggle
between modes, depress the MODE button once each time a mode change is desired. The VOPEX will cycle through the modes
of operation, then return to the first mode (1 to 2, 2 to 3, 3 to 4, etc). The following table details the modes of operation.
MODE
DESCRIPTION
1- INSTANTANEOUS
Both users have control of the CPU
simultaneously.
2- DELAY
The first user with an active device gets control of
CPU. The second user is locked out until after 5
seconds of inactivity from the first user.
3- USER 1
"USER 1" has sole access. Other users are
locked out.
4- USER 2
"USER 2" has sole access. Other users are
locked out.
5- USER 3
"USER 3" has sole access. Other users are
locked out.
6- USER 4
"USER 4" has sole access. Other users are
locked out.
Keyboard Command Mode
In order to control the other features of the VOPEX with the keyboard, Command Mode must be enabled. To enter
Command Mode from the keyboard:
Press
When the Command Mode is enabled, all 3 status lights on the keyboard will illuminate and both LED's on the VOPEX will blink
continuously to indicate Command Mode is enabled. See the table below for functions that are available while in Command
Mode.
NOTE: The user must exit Command Mode in order for the CPU to switch to the selected mode. To exit Command Mode,
press ESC on the keyboard. The mouse will not operate while in Command Mode.
NOTE: While in Command Mode, when a proper programming command is entered and is recognized by the switch, the
LED's on the keyboard will flash once to indicate acceptance. The user must exit Command Mode (by pressing ESC) to
see a change take effect in the switch operation.
NOTE: The VOPEX will automatically exit Command Mode after 5 seconds of inactivity by the user if the user does not
manually exit Command Mode.
(ACCENT
+
~
Ctrl
KEY)
`
`
5
INDICATOR LEDS
Advertisement
Table of Contents
