Initial Startup; Figure 8- Serimux Secure Configuration Menu Via Serial Connection - Network Technologies SERIMUX-S-x Installation And Operation Manual

NTI SERIMUX SERIES SSH CONSOLE SWITCH

INITIAL STARTUP

The following instruction will enable the user to quickly make port connections using a terminal connected to the
"CONSOLE" port. For instruction to make quick connection using the Ethernet port and Web Interface, see page 43.
1. Make sure the SERIMUX is turned OFF.
2. Using the serial console device connected to the port labeled "CONSOLE", start the terminal program (e.g. Windows
HyperTerminal) and configure it as follows:
direct connection (using the appropriate CPU local serial Com port)
•
115200 bps
•
8 bits
•
no parity
•
1 stop bit
•
no flow control
•
ANSI or VT100 terminal mode.
•
3. Power ON the SERIMUX. Wait for the SERIMUX login prompt.
root
4. At "login as: " type <
nti
5. At "password" type <
6. A shell prompt will be displayed "-sh-2.05b# "
To access the configuration menu:
Type <serimuxconfig> to open Serimux Secure Configuration Menu. (See Figure 8) Use menu structure
to configure SERIMUX.
-OR-
To make a connection with a host:
Type <portmenu> to open a port connection menu. Then type a port number and press <Enter> to make a
connection with a host. (See Figure 9)

Figure 8- SERIMUX Secure configuration menu via serial connection

> (all lowercase letters) and press <Enter>.
> (all lowercase letters) and press <Enter>.
10