Host Set-Up - Ibm As/400, 5250 Cu Mode - Axis 570 User Manual

Host Set-up - IBM AS/400, 5250 CU mode

Before you begin
Automatic Set-up
Setting Parameters
Printer Device
Descriptions
AXIS 570/670 MIO User's Manual
You have decided that the AXIS 570/670 MIO is going to run in
5250 CU mode, to provide optimum AS/400 performance.
This setup procedure is based on the OS/400 autoconfiguration
feature. Full autoconfiguration support requires OS/400 Version 3
Release 1 or higher. If you have an earlier release than this, refer to
Manual Set-up, on page 47.
Make sure that the SYSVALs QAUTOCFG and QAUTORMT are
enabled. To enable automatic configuration of the APPC-controller,
set AUTOCRTCTL to *YES in the line description. Also make sure
the user QUSER has enough memory space allocated, *NOMAX is
recommended.
Prior to attempting autoconfiguration, the following Parameters must
be correctly set in the Print Server:
• DEVICE_EMUL must be set to 5494
• H1_ADDR must be set to the MAC address of the host
• H1_LU_NAME must be set to the host system LU name
• H1_NW_NAME must be set to the host system Network Name
• AUTODIAL must be set to YES in order to activate
autoconfiguration.
These parameters are explained in detail in the AXIS 570/670 MIO
Set-up, on page 61.
Through autoconfiguration, the APPC controller, APPC device, RWS
controller as well as printer device descriptions for the logical printers,
will be created automatically.
Section 3: Setting Up - SNA
SNA
45