Axis 570 User Manual page 117

UNIX
Section 8: Setting Up - UNIX
Read-back of
information
Debugging using the
Hex Dump Mode
116
The PostScript font can be any font that is installed in the printer; if no
font is specified, Courier will be used.
Example:
The following entries are needed in your config file to set up logical
printer number 2 for ASCII to PostScript conversion with the
stated printing characteristics.
PR2_FILT.:POSTSCR
PR2_SIZE.:LETTER
PR2_ORNT.:LANDS
PR2_FORM.:48 0 120 60 30 50
PR2_FONT.:Helvetica
The AXIS 570/670 MIO supports bi-directional printing. The
information from the printer is read back on the MIO port when the
parameter PRx_IN has the default setting of AUTO. However, it is
required that the printer also supports bi-directional printing.
Through the parameter PRx_IN the communication can be disabled.
Example:
The following entry is needed in your config file to disable the
bi-directional communication:
PR1_IN. : NONE
When hex dump mode is activated, the print data is printed as
hexadecimal byte values rather than characters; printer control
commands are also printed as hex values. This allows you to inspect the
control and print characters sent to the printer, which is a useful
debugging facility for the more difficult printing problems.
Example:
(PostScript conversion on)
(page size = letter)
(orientation = landscape)
(48 LPP, 0 CPL, 12 CPI, 6 LPI,
3 mm left margin, and
5 mm top margins)
(font = Helvetica)
(Read-back of information)
AXIS 570/670 MIO User's Manual