Axis 570 User Manual page 34

AXIS 570/670 MIO User's Manual
AXIS 670 MIO Token Ring
If you are a IBM AIX user, you will probably not have access to a
RARP daemon. If this is the case, you may use either the ARP or
BOOTP methods instead.
1. Append the following line to your Node Address table. This is
typically performed using the command
<node address> <host name>
Where the node address is either the serial number found on the
underside label of the AXIS 670 MIO or a Locally Administrated
Address.
Example:
00:02:31:48:00:61 npsname
2. Update your host table and alias name databases, as described
previously.
3. If it is not already running, start the RARP daemon. This is
typically performed using the command
4. Restart the AXIS 670 MIO to down-load the Internet address.
Section 2: Basic Installation
/etc/ethers
rarpd -a.
:
33