Axis 570 User Manual page 53

SNA
Section 3: Setting Up - SNA
Creation of printer
devices
52
To create a printer device description, type CRTDEVPRT. Set your
choices in the panel as follows:
• Device description: Select the name you want for the device.
• Device class: Select *RMT.
• Device type: The device type is related to the setting of the Printer
Server Parameter PREMUL. See the mapping in the table below.
Select the device type as in the mapping table below.
PREMUL
5224_TX
5225_TX
5256_TX
4214_TX
4230_TX
3812_TX
3816_TX
3816S_TX
• Device model: Select model as in the table above
• Local location address: Select the local location address of the
device. The local address chosen is related to the Logical Printer
concept in the Print Server. Local location addresses 01-08 are
mapped to Logical Printers #1-8 in the Print Server, i.e. if you want
the printout directed to this device to be sent to Logical Printer #2,
choose 02 as local location address. You cannot use local address 00,
or local addresses above 08, as there are only eight Logical Printers
in the AXIS 570/670 MIO. The maximum number of printer
devices supported by the AXIS 570/670 MIO is determined by the
setting of the Print Server Parameter N_PRT_DEV. Refer to
N_PRT_DEV, on page 46.
• Attached controller: This parameter must match the controller
description name of the RWS controller you created above.
• Font identifier: Select the desired font identifier.
Device type Device model
5224 1
5225 1
5256 1
4214 2
4214 2
3812 1
3812 1
3812 1
AXIS 570/670 MIO User's Manual