Axis 570 User Manual page 162

Updating Using the
NetPilot
Upgrading over the
Network using FTP
Caution
AXIS 570/670 MIO User's Manual
This is the most convenient method for updating AXIS Network Print
Server Software. An Installation Wizard is available to guide you
through the necessary procedures, simply click on the Upgrade icon of
the AXIS NetPilot™ Toolbar to display the Upgrade Wizard menu.
To upgrade over the network using FTP you will need the following:
• The file with the new print server software. The name of this file is
in the form product.version, e.g.
5.33. You may use any of the aforementioned methods to obtain
the new file.
• The AXIS 570/670 MIO must also be installed on the network
with TCP/IP as described in Basic Set Up for TCP/IP, on page 26.
Follow the procedures below to upgrade the AXIS 570/670 MIO:
1. Log in to the AXIS 570/670 MIO with the command
ftp <host name>
your system host table.
2. You will be prompted for user id and password. Use the user id
root, which has the default password
with the highest priority).
3. Issue the command
4. Issue the command
<software name>
e.g.
57m_533.bin
5. Wait for the Flash load to finish. This normally takes 1 to 4
minutes. The unit will then automatically restart with the new
print server software.
Be careful not to interrupt the file transfer. If the transfer is
interrupted the AXIS 570/670 MIO may have to be re-initialized
by your dealer.
6. Log out using the command
your FTP version.
Appendix D: Updating the Software
57m_533.bin
where <
host name>
pass
to change to binary transfer mode.
binary
put <software name> flash
is the name of the new print server software,
.
quit, bye
for software release
is the name assigned in
( is the user id
root
where
or depending on
exit
161