Axis 570 User Manual page 60

Note:
Concentrator
gateway, NetWare
AXIS 570/670 MIO User's Manual
Pooling of LUs may not be used for AXIS 570/670 MIO.
If you are bridging between Token Ring and Ethernet through the
IBM 3174 Gateway, you have to flip MAC address bit order
bytewise for all MAC addresses on both sides.
Example: 00408C1B06D4 -> 000231D8602B
This is an outline of the procedure for configuring to a Novell
NetWare for SAA v 2.0 Server. More information is provided in the
Support section of the Axis WWW Home Page.
1. Customize the AUTOEXEC and STARTUP files on the server.
Add the LOAD statements for the LAN and WAN cards, the
BTRIEVE database, and the NetWare for SAA 2.0 Gateway
i.e. LOAD COMMEXEC and LOAD NWSAA.
2. Configure the Communication Executive (this and the following
subjects are done on a WorkStation).
3. Configure SNA Network ID. Either change the default value or
let it stay on default.
4. Configure Data Link Adapters. The configuration is done on the
Data Link Adapters Definitions screen by pressing insert for a new
adapter config, then you always enter the Logical adapter name,
Link type, Logical adapter number and Service status.
5. Configure PU and LUs. On the Configure PU Profile screen you
can set default LU attributes, starting dependent LU address,
number of dependent LUs, give CP a name, enable off-line test
mode, status assignment of LUs activated by host, status call host
at workstation attach, status PU profile start-up and logical
adapter name. On the Configure Dependent LUs screen you can
set VTAM LU name, lock for a session, LU type and model and
preserve host session.
6. Assign LU Resources and Access Control Lists (ACLs). On the
Configure Dedicated LUs you can dedicate a LU to a person or
device or group of persons. This person(s) is described in the access
control lists.
Section 3: Setting Up - SNA
SNA
59