Axis 570 User Manual page 30

Notes:
Using ARP in Windows
95, Windows NT
AXIS 570/670 MIO User's Manual
Please note that although it is recommended practice to refer to
the host name when accessing your AXIS 570/670 MIO, it is
perfectly acceptable to replace this name with the Internet address
in all instances. Indeed, this becomes a necessity when:
• the host name has not been included in your system host table
• attempting to use the ARP command in a Windows 95 or
Windows NT environment.
The latter point is demonstrated in the first of the examples below.
In both Windows 95 and Windows NT the Internet address can be set
using the ARP method. Perform the following commands to
down-load the Internet address and verify correct Internet
communication.
AXIS 570 MIO Ethernet:
Start a DOS window. Type the following command:
arp -s <Internet address> <Ethernet address>
ping <Internet address>
arp -d <Internet address>
Example:
arp -s 192.168.3.191 00-40-8c-10-00-86
ping 192.168.3.191
arp -d <192.168.3.191>
The host will return Reply from 192.168.3.191... or
some similar message. This indicates that the address has been set
and the communication is established.
Section 2: Basic Installation
29