Axis 570 User Manual page 135

Appendix B: The Parameter List
Editing from a
Macintosh
Editing from
an IBM host
134
4. Down-load the config file. Command:
If you are using an Apple EtherTalk system you will need MacTCP on
your computer, and an ftp utility (e.g. Fetch or Anarchie) to get access
to the config file from your Macintosh. Proceed as described above.
Once communication with an IBM host has been established, all the
AXIS 570/670 MIO parameters can be edited by printing a file
containing special configuration commands. To start the
configuration, the command
protect your settings, a password must be provided. By default, the
password is . When all parameters are set, the command
pass
used to store the parameters permanently. The command
leaves the configuration mode and resumes normal printing. The
syntax for the file to print is:
%CONFIG+ <password;>
IBM_PRINTING_PARAMETER_NAME = VALUE;
SAVE;
%CONFIG-
In order to maintain backward compatibility and increase security,
many parameters that are not related to the IBM printing operation
have to be preceded by the
parameters are set, enter
are clearly marked in the parameter listing on the
%CONFIG++
following pages.
%CONFIG+ <password;>
IBM_PRINTING_PARAMETER_NAME = VALUE;
%CONFIG++
PARAMETER_NAME = VALUE;
%CONFIG--
SAVE;
%CONFIG-
put config CONFIG↵
is entered in the file. To
%CONFIG+
command. When all
%CONFIG++
. The parameters requiring
%CONFIG--
AXIS 570/670 MIO User's Manual
is
SAVE
%CONFIG-