Axis 570 User Manual page 64

AXIS 570/670 MIO User's Manual
• LU Name
Name: , Default:
LU_NAME
seven characters of the Print Server serial number, in reverse order,
i.e. a print server with serial number 00 40 8C 1B 06 D4 will have
the default LU Name A4D60B1C. This will be the name of the
APPC device created during autoconfiguration.
Environment: AS/400 only. 5494 emulation.
Description: This parameter defines the LU name of the Print
Server. The default value is normally used.
If an RWS controller for this Print Server is already defined on the
AS/400 system, you may issue the DSPCTLD command to make
sure that this parameter matches the Remote location name (RMT-
LOCNAME).
The LU Name may comprise the letters A-Z and/or numerals 0-9,
but must begin with a letter. The letters used should all be in
and a maximum of 8 characters are allowed.
UPPERCASE
• Control Point Name
Name: , Default:
CP_NAME
seven characters of the Print Server serial number, in reverse order,
i.e. a print server with serial number 00 40 8C 1B 06 D4 will have
the default CP Name A4D60B1C. This will be the name of the
APPC controller created during autoconfiguration.
Environment: AS/400 only. 5494 emulation.
Description: This parameter defines the Control Point name of the
Print Server. The default value is normally used.
If an APPC controller for this Print Server is already defined on the
AS/400 system, you may issue the DSPCTLD command to make
sure that this parameter matches the Remote control point name
(RMTCPNAME).
The CP Name may comprise the letters A-Z and/or numerals 0-9,
but must begin with a letter. The letters used should all be in
and a maximum of 8 characters are allowed.
UPPERCASE
• Host MAC Address
Name: , Default:
H1_ADDR
Environment: Mainframe and AS/400
Section 3: Setting Up - SNA
, where "xxxxxxx" is the last
Axxxxxxx
, where "xxxxxxx" is the last
Axxxxxxx
FF FF FF FF FF FF
SNA
63