Axis 570 User Manual page 33

Section 2: Basic Installation
Notes:
Using RARP in UNIX
32
The ARP command can vary between different UNIX systems.
The 802.5 argument is only required for IBM AIX systems, and
some BSD type systems expect the host name and node address in
reverse order. Furthermore IBM AIX systems will require the
additional argument ether. For example:
arp -s ether <host name> 00:40:8c:10:00:86 temp
Please note that when you execute the ping command for the first
time, you may experience a significantly longer response time than
is usual.
Follow the step-by-step procedure below to use the RARP method:
AXIS 570 MIO Ethernet
1. Append the following line to your Ethernet Address table. This is
typically performed using the command
<Ethernet address> <host name>
Example:
00:40:8c:10:00:86 npsname
2. Update your host table and alias name databases, as described
previously.
3. If it is not already running, start the RARP daemon. This is
typically performed using the command
4. Restart the AXIS 570 MIO to down-load the Internet address.
/etc/ethers
rarpd -a.
AXIS 570/670 MIO User's Manual
: