As/400 Sna Printing; The As/400 Host System Checklist - Axis 5470 User Manual

10

AS/400 SNA Printing

AS/400 SNA Printing

Important!
SNA is not available for all AXIS 5470e units. Please refer to Product Model Summary, on page 7.
If you are using OS/400 Version 3 Release 1or higher, the AS/400 host in 5494 CU Mode will be configured
automatically. The information provided in this section describes this automated configuration procedure.
For information regarding manual configuration, refer to the AXIS Network Print Servers technical reference that is
supplied on the AXIS Product CD or see the Technical Notes that are available on the Axis Web site.

The AS/400 Host System Checklist

Note:
The AS/400 Parameter Checklist, on page 47 is a table where you can enter the values described in
this section for future reference.
1. Type DSPNETA on the AS/400 command line. For future reference, note the values of the
Local network ID and Default local location parameters. Press F3.
2. AXIS 5470e/570: Type WRKLIND *ELAN (AXIS 670e: WRKLIND *TRLAN)to get a list
of all line descriptions on the system. Type 5 in front of the line description and press Enter.
3. Press F11 to display keywords.
4. For your future reference, note the values of the Local adapter address(ADPTADR)
and Maximum Controllers (MAXCTL) parameters. Press return to view the active
switched controllers display and verify that the number of controllers does not exceed
MAXCTL.
5. Press Enter repeatedly to display the SSAP list. Make sure there is at least one SSAP entry
dedicated for SNA. For your future reference, note the SSAP value for this entry.
6. Press Enter repeatedly to display the Autocreate controller (AUTOCRTCTL)
parameter. Ensure that the AUTOCRTCTL parameter is set to *YES. Press F3 to return to the
command line.
7. Type DSPSYSVAL QCHRID and press Enter. Note the code page for future reference.
Press F3.
8. Type DSPSYSVAL QAUTOCFG and press Enter. Check that the parameter is set to ON(1).
Press F3.
9. Type DSPSYSVAL QAUTORMT and press Enter. Check that the parameter is set to ON(1).
Press F3.
AXIS 5470e/570/670e User's Guide