Axis 570 User Manual page 18

AXIS 570/670 MIO User's Manual
1. Remove the cover plate over the MIO slot.
2. Record the AXIS 570/670 MIO serial number. The serial number
is the default Ethernet or Node address and is found on the back of
the AXIS 570/670 MIO circuit board. You will need it during the
network configuration.
3. Switch off the printer.
4. For AXIS 670 MIO only: Select the network Ring Speed using the
jumper S4. With the jumper in place, the network speed is
16 Mbit/s. Remove the jumper to select 4 Mbit/s.
5. Slide the AXIS 570/670 MIO board into place.
6. Tighten the two screws securing the rear panel.
7. Switch on the printer.
The hardware installation is now completed.
The AXIS 570/670 MIO board installed (HP LaserJet 4+)
Section 2: Basic Installation
17