Table of Contents
Advertisement
Installing the lens
The lens seals the projection head, preventing contaminants from entering the main electronics area.
Notice. If not avoided, the following could result in property damage.
•
Do not operate the product without a lens installed.
•
Always use a lens plug when installing or moving the product. This prevents contaminants from
entering the product.
•
Do not insert the lens into the product at an angle. This can damage the lens and the optical
components inside the product.
•
Always place the lens cap onto the lens when moving the projector to avoid scratching the lens.
•
Remove the lens cap before turning the product on to avoid damaging the lens.
1. Before installing the lens, make sure you turn off the projector and the circuit breaker
switches.
2. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
3. Position the lens so the UP label is facing upward.
4. Turn the clamp on the lens mount to the open position.
CP4415-RGB and CP4420-RGB Gen2 Installation and Setup Guide
020-103773-01 Rev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
27
Advertisement
Table of Contents
