Error Code Table - Canon imageCLASS 2300 Sending Manual

Error Code Table

If an error occurs when transmitting or receiving an I-Fax, an error code will be
displayed on each report.
This section describes specific error displays of I-Fax.
When a transmitting job is not completed properly, the completion code is printed
on the RESULT column of the Activity Report or the TX Report. Take the
recommended solution procedure that corresponds to the completion code.
NOTE
For error codes displayed while performing normal fax transmitting and receiving, see
Chapter 12, "Troubleshooting," in the Facsimile Guide.
Completion Code
#0037
#0751
#0752
Meaning
-The memory is full (Memory
for I-Fax reception is full).
-Reception is rejected
because the printer is not
ready to print.
-FTP server is not set up.
-The network with the FTP
server is cut off. (Cannot
connect to the destination, or
the line is severed in the
middle.)
-Incorrect settings of SMTP/
POP3 server name for e-mail
or I-Fax.
-The server is not set up.
-The network is cut off.
Solution
-Wait until automatically
recovered.
-Print out documents stored
in the memory with
MEMORY RX or
RECEIVED IN MAIL BOX.
-If an error occurs in the
printer, eliminate the cause.
-Check the destination.
-Check the network.
-Check the FTP server
settings.
-Check settings of the
SMTP/POP3 server name
in Additional Functions.
-Check that the SMTP/
POP3 server works
properly.
-Check the network
conditions.
Error Code Table
6
6-5