Concluding Steps; Removing A Bbu - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

The hooks on the air duct will lock in the narrow ends of the keyhole slots on
the FBU holder.
Ê Ensure that the locking handle on the FBU holder properly snaps in place
(2).
Ê If applicable, install a RAID controller as described in section
expansion cards" on page
Ê Connect the FBU cable to the TFM (3, see close-up).
9.5.3.4

Concluding steps

"Reassembling" on page 62
Ê
"Connecting the server to the mains" on page 72
Ê
"Switching on the server" on page 73
Ê
Ê If applicable, "Updating RAID controller firmware" on page 88
"Enabling SVOM boot watchdog functionality" on page 93
Ê
9.5.4

Removing a BBU

Upgrade and Repair Unit
(URU)
Tools: tool-less
V
CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section
protection" on page
TX2540 M1
227.
42.
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 5 minutes
"Installing
"Environmental
249