Fujitsu Primergy TX200 S2 Start Manual

�����������
�����������������������������������������������
��������������������������������������������������
���������������������������������������������������������������
�����������������������������������������������������������������
n PRIMERGY TX200 S2 Manuals
Manuals for this server can be accessed from the section below of the PRIMERGY Document and Tool CD (Disc 2).
[CD-ROM Drive] :\MANUAL\INDEX.PDF
Manuals can be displayed using Acrobat
1
Checking the items
supplied
Check the contents in the package using
the "Contents List".
If any items are missing, inform an office listed in
the "Contact Information".
3

Installing hardware options

If hardware options have been purchased separately, install them before installing the Operating Sys-
tem.
In the following case, it is not required to install the hardware options.
- Custom Made Service
nPoint to note before installing hardware
options
When installing hardware options, perform operations after
reading the following manuals.
������������ "Chapter 7 Installing Hardware Options"
"PRIMERGY Server Books"/
���������������
"Supplement"
Install the OS before installing the following options.
Installing the OS after options have been installed will
cause installation operations to end in an error.
- Non-system hard disks
- External SCSI optional devices (Backup cabinet, DAT
unit, etc.)
TX200 S2
® Reader ® or Adobe ® Reader
1
® . If using Acrobat ® Reader ® , use version 4.0 or later.
2
Reading and understand-
ing "Safety Precautions"
Before using this server, be sure to read and un-
derstand the attached "Safety Precautions".
Also check it when connecting, installing hardware options
and setting up this server.
n Available hardware options and
installation locations
���
������
��������������
After installing hardware options, check that the order and
place of installation is correct and cables are correctly at-
tached.
B7FH-2971-02EN-00
�����������������������
�������������������������