Handling The Anti-Tilt Bracket - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual
Server primergy tx2540 m1
Hide thumbs
Also See for PRIMERGY TX2540 M1:
- Upgrade and maintenance manual (422 pages) ,
- Operating manual (92 pages)
Table of Contents
Advertisement
Installing the system fan holder
Ê Insert the system fan holder into its two guides (3).
Ê Carefully lower the system fan holder into the chassis until the two locking
tabs (see close-ups) engage.
4.9
Handling the anti-tilt bracket
Figure 32: Handling the anti-tilt bracket
Removing the anti-tilt bracket
Ê Loosen the two knurled thumb screws on the anti-tilt bracket (see circles).
Ê Remove the anti-tilt bracket.
Installing the anti-tilt bracket
Ê If applicable, remove the left knurled thumb screw from the middle screw
hole (A) and assemble it to the left screw hole (B).
Ê Fit the anti-tilt bracket onto the bottom edge of the server rear.
Ê Secure the anti-tilt bracket on the rear of the server with two knurled thumb
screws (see circles). Screw the knurled thumb screw of the left side first.
TX2540 M1
Upgrade and Maintenance Manual
Basic hardware procedures
75
Advertisement
Table of Contents
