Removing The Fbu - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Server primergy tx2540 m1

Hide thumbs Also See for PRIMERGY TX2540 M1:

Table of Contents

Removing the FBU

Figure 179: Removing the FBU holder from the chassis

Ê Carefully disconnect the FBU cable from the RAID controller (1).

Ê Lift up the green locking handle on the FBU holder (2) while sliding the FBU

holder in the direction of the arrow as far as it will go (3).

After that, the hooks on the air duct will rest in the wide ends of the

keyhole slots on the holder.

Ê Lift the FBU holder out of the chassis.

Upgrade and Maintenance Manual

Expansion cards and backup units