Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual page 373

"Switching on the server" on page 73
Ê
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section
information backup / restore" on page
"Verifying the system time settings" on page 95
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 100.
Ê After replacing the system board in a server running Linux OS, update the
MAC address of the onboard network controller in the related NIC definition
file as described in section
environment" on page
"Enabling SVOM boot watchdog functionality" on page 93
Ê
"Enabling BitLocker functionality" on page 98
Ê
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable,"After replacing the system board" on page 103
TX2540 M1
"Looking up changed MAC / WWN addresses"
"Updating the NIC configuration file in a Linux
97.
363.
Upgrade and Maintenance Manual
System board and components
"Verifying system
87.
"Note on network
373