Software Configuration; Removing The Ufm; Preliminary Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

14.3.1.4 Software configuration

The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.

14.3.2 Removing the UFM

Upgrade and Repair Unit
(URU)
Tools: Phillips PH1 / (+) No. 1 screw driver

14.3.2.1 Preliminary steps

"Disabling BitLocker functionality" on page 77
Ê
"Locating the defective server" on page 45
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the server from the mains" on page
Ê
"Getting access to the component" on page
Ê
TX2540 M1
Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
48.
49.
343