Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual page 378

Converting a tower model to a rack model
Ê Lift off and remove the right side cover as shown.
I
The right side cover is no longer required.
Ê Leave the server in its upside down position.
Removing rubber feet
Figure 284: Removing rubber feet
Ê Using a slotted screw driver, slightly pry up on each rubber foot until it
detaches.
Ê Bring the server back to its horizontal position.
I
At least two people are needed to turn over a fully equipped server.
Remove hard disk drives and power supply modules in order to
facilitate the task.
378 Upgrade and Maintenance Manual
TX2540 M1