System board and components
Figure 280: Installing the system board (C)
Ê Secure the system board with the ten screws (see circles).
I
Screw torque: 0.6 Nm (not applicable for the Japanese market)
Tighten the screws in a cross diagonal pattern.
Ê Verify the settings on the new system board (see figure
on page
413).
Preparing the processor socket load plates on the new system board
Ê Remove the protective cover on the new system board as described in
section
"Removing the protective cover" on page
370
Upgrade and Maintenance Manual
"Onboard settings"
272.
TX2540 M1