Installing The New Hot-Plug Psu; Concluding Steps; Replacing The Power Backplane; Preliminary Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Power supply units
6.3.3.3

Installing the new hot-plug PSU

Ê Install the hot-plug PSU as described in
page 117.
6.3.3.4

Concluding steps

Ê Connect the power cord to the new hot-plug PSU and secure it with a cable
tie as described in section
Ê Only when replacing a hot-plug PSU in a non-redundant configuration:
"Switching on the server" on page
"Performing a fan test after replacing a defective fan" on page 105
Ê
6.3.4

Replacing the power backplane

Field Replaceable Unit
(FRU)
Tools: tool-less
6.3.4.1

Preliminary steps

"Locating the defective server" on page 45
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the server from the mains" on page 48
Ê
"Getting access to the component" on page 49
Ê
"Removing the system fan holder" on page 74
Ê
6.3.4.2

Removing the hot-plug PSUs

Ê Remove all hot-plug PSUs as described in
page 119.
122
"Connecting the server to the mains" on page
73.
Upgrade and Maintenance Manual
"Installing a hot-plug PSU" on
Hardware: 15 minutes
"Removing a hot-plug PSU" on
72.
TX2540 M1