Concluding Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Figure 128: Removing the SAS expander board
Ê Loosen the captive knurled thumb screw on the SAS expander board (1).
Ê Slide the SAS expander board to the left as far as it will go (2).
The shoulder screw caps on the carrier will rest in the wide ends of the
keyhole slots on the SAS expander board (3).
Ê Remove the SAS expander board from the chassis.
Ê Disconnect the two SAS cables from connectors "X5" and "X6" on the SAS
expander board.
Ê If you don't install a new SAS expander board, change SAS cabling
according to the new server configuration as described in section
plans" on page
7.5.2.3

Concluding steps

"Installing the system fan holder" on page 75
Ê
"Reassembling" on page 62
Ê
"Connecting the server to the mains" on page 72
Ê
"Switching on the server" on page 73
Ê
"Enabling BitLocker functionality" on page 98
Ê
TX2540 M1
391.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Cabling
199