Installing The Bezel - Gateway 9515 User Manual

Installing the bezel

Important
To install the bezel (optional):
1
With the server pulled out from the cabinet, align the holes in the handle with the
holes in the front sides of the server.
2
Attach the handles to the sides of the server with two mounting screws on each side.
3
Push the server, with the handles attached, into the cabinet to determine which holes
in the front posts of the cabinet that the holes in the handles will line up with.
4
Install the mounting nuts (nuts equipped with spring clips that come with most server
cabinets) into the holes in the front posts of the cabinet.
5
Push the server into the cabinet again.
The bezel is held in place by the server handles. If you are not
installing the bezel, you do not need to install the handles.
Mounting screw
Mounting screw
www.gateway.com 19