Installing A Cd Or Dvd Drive - Gateway 9515 User Manual

Installing a CD or DVD drive

To install a CD or DVD drive:
1
Follow the instructions in
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
Caution
2
Follow the instructions in
3
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4
Remove the CD/DVD drive carrier by pressing the blue lever at the back of the carrier
and pushing the carrier out the front of the server.
5
Place the CD or DVD drive in the drive carrier (included with your server) by aligning
the two holes in the left side of the drive with the two alignment pins in the carrier,
then lowering the right side of the drive into the carrier until it clicks into place.
Screws
"Preventing static electricity discharge" on page
The CD or DVD drive is not hot-swappable. Before installing or
removing the drive, make sure that power is turned off.
"Opening the server case" on page
Drive carrier
www.gateway.com
44.
Interposer board
CD or DVD drive
43. Make
61